Proudly Supported By Proudly supported by Century Batteries
DIY Guides

⚙Removing the Rumble

After some drama, I am finally reinstalling the original tailshaft back into the BA Falcon XR6 Turbo. With my new single-piece tailshaft not fitting up properly, I had this original one which I got reconditioned by Hardy Spicer. The centre bearing and universal joint both needed to be replaced, with the bearing being a particularly common part to wear out and cause issues.

We’ll run this original shaft for a while, before swapping it out later for the single-piece one.

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to top button